7
INSTALLATION: METHOD 1
SPARTAN
INSTALLATION: METHOD 1
SECURING WITH COACH SCREWS
1. Mark out the ceiling cut-out as per minimum hole dimensions below. Please refer to the size table on
pages 6. Cut out the hole for lift to fit through.
2. Frame up the ceiling joists and timber frame using a qualified tradesperson.
3. Route the Audio-Visual cables to the lift position in the ceiling. See the Cable Management instructions to
be followed post install.
4. A double power point is required in the ceiling to power the Spartan and the display panel.
NOTE: Access to the power point in the ceiling is advisable.
5. Power the Spartan unit on the ground (using the Wiring Instructions) and open the screen tilt to
approximately 90°. (Enough for access to the roof panel and the inner section.)
6. Remove the side Trim Panels to allow access to the mounting holes.
