Ultrak KD6 Z Series, Руководство по эксплуатации и программированию

Страница: 15 / 20

5
Perform the following procedure to program a PreShot in the KD6 Z-Series Dome using a
JPD100, JPD100P, or JPD200P Controller.
JPD100, JPD100P, or JPD200P Controller
a. Adjust the pan, tilt, zoom, and focus of the KD6 Z-Series Dome using the joysticks on the
controller until the desired scene is displayed on the monitor.
b. Press the PreShot number(s), 1-64 , on the numeric keypad.
c. Press PRGM on the function keypad.
d. Press Enter .
The PreShot is stored in the KD6 Z-Series Dome.
4.1.1 Editing PreShots
Follow the procedures for programming PreShots.
4.2 PROGRAMMING VECTORSCANS
VectorScans are one or more PreShots, from the same unit, grouped together and saved with a
number. The amount of time (dwell) the scan remains at each PreShot can be programmed and
saved in the VectorScan. A total of three (1-3) VectorScans are programmable per scan. Each
VectorScan File can contain a maximum of 16 PreShots.
Perform the following procedure to program and store a VectorScan (in the control camera
displayed on the programming controller). Use the worksheet in paragraph 4.3 to log
programmed VectorScans.
Press the OPT key.
Press 4 (PROG).
Press 2 (VectorScan
†
).
Enter the VectorScan # (1-3)
Press Enter .
Enter the 1
st
PreShot # (1-64) .
Press Enter .
Enter a dwell time (0-30 seconds) .
Press Enter .
Enter the next PreShot # (1-64) .
Press Enter
Enter a dwell time (0-30 seconds) .
†
Tour (Selection 1) on the JPD Series Controller is not available for the KD6 Z-Series product.