ULTRAFRYER ULTRATHERM REO-1620SE, Руководство по эксплуатации

Страница: 9 / 18

A. INSTALLATION
1. Place the Rethermalizer in the location where it is to be operated.
2. Have a licensed plumber level the Rethermalizer and connect a 1/2” copper water line equipped with a
WATER SHUT-OFF VALVE
to the plumbing connection on the rear of the Rethermalizer.
NOTE:
Water hardness may affect the performance and longevity of component parts coming in direct
contact with the water. Therefore, the local water supplier should be contacted to determine if the
water to be used with the appliance should be treated with a filter, strainer, softener, and/or descaler.
WARNING: ULTRAFRYER SYSTEMS INC. RESERVES THE RIGHT TO VOID WARRANTY
OF COMPONENT PARTS WHICH FAIL OR ARE DAMAGED BY HARD WATER.
3. Have a licensed electrician perform the following:
TERMINALS
a. Connect an UL approved 3 wire 30 ampere electrical
cord to the terminal inside the units electrical box
shown :
b. Install a NEMA rated electrical plug on the elctrical
cord.
c. Install a “mating” NEMA rated electrical receptacle on
the wall behind the Rethermalizer operating location.
d. Connect the building ground to the ground lug located
inside the unit’s electrical box.
4. Test operate the Rethermalizer as follows:
a. Ensure the controls listed below are in the proper position:
APPLICABLE CIRCUIT BREAKER IS ON
ELECTRICAL PLUG IS CONNECTED TO THE ELECTRICAL WALL RECEPTACLE
WATER SHUT-OFF VALVE IS OPEN
DRAIN VALVE LEVER IS CLOSED
b. Fill the tub with water to the water overflow ports on the RIGHT side of the tub.
c. When the tub is filled:
1) Turn the ON/OFF switch to the ON position. The AMBER lamp will LIGHT indicating the
unit is being powered up. The RED lamp on the panel will LIGHT indicating the water is
being heated.
2) When the Pre-Set temperature of the water is reached the RED lamp will go OFF.
3) Turn the
ON/OFF
switch to the
OFF
position, then turn the drain valve lever to the
OPEN
position and CAREFULLY drain water in the tub into a floor drain.
CAUTION: ALLOW ALL METAL SURFACES OF THE RETHERMALIZER TO COOL PRIOR
TO PROCEEDING.
B. INITIAL CLEANING
1. Remove and THOROUGHLY wash the following items in the 3 compartment sink with HOT water
and soap, rinse these parts with HOT water and allow them to air dry:
STAINLESS STEEL CHUB BASKET
STAINLESS STEEL TUB GRILL
2. THOROUGHLY wash the Rethermalizer tub with HOT water and soap; then rinse the tub with HOT
water and allow it to air dry.
3. Wipe the top, side and front surfaces of the Rethermalizer with a
HOT
damp cloth.
4. When the chub baskets, grill and tub are dry, replace the grill and baskets in the tub.
6