ultracomfort UC490, Руководство пользователя

Страница: 15 / 28

15
Troubleshooting
The setup of the chair requires the steps to be conducted as stated. If the chair
does not operate correctly one of the following may have occurred:
• The incorrect buttons were used during setup.
• The buttons were released prior to the chair reaching the final setup position.
• Power disconnected or lost during setup.
The position of the chair when using the setup procedure will not affect
operations. If any of these issues occurred and the chair does not seem to
operate correctly, please repeat the Setup Procedure.
Programming the Memory Buttons S5, S6, S8 and S10
Press one of the preprogrammed buttons (S5, S6, S8, S10) and hold until the chair
stops. Press buttons (S1 thru S4, S11 and S12) to micro adjust those positions
to suit your needs. Use the following procedure to reprogram (S5, S6, S8, S10)
buttons after you have the chair in your desired position.
Press and hold program button (SP). The back light goes off while pressed.
1. In about 3 seconds the backlight will start flashing (one flash)
2. Within 5 seconds, press one of the memory buttons (S5, S6, S8, S10) to save
the position to the button pressed. The back light will return to non-flashing
position indicating that the new position is stored.
If a programmable memory button is not pressed within 5 seconds, or a
nonprogrammable button is pressed, then the programming sequence is aborted
and you will need to repeat steps 1 to 3 above. You may reprogram the memory
buttons as often as you like.
Factory Reset
Resets all the programmed buttons (S5, S6, S8 and S10) back to the factory
settings.
1. Press and hold program button (SP). The backlight goes off while button is
pressed.
2. In about 4 seconds the backlight will start flashing.
3. Within 5 seconds, press button (S1). The backlight will change to non-flashing.
4. Within another 5 seconds, press button (S4). Factory reset is done.
If button (S1) is not pressed within 5 seconds, or a different button is pressed,
then the programming sequence is aborted and you’ll need to repeat steps 1 to
4 above.