ultracomfort UC490, Руководство пользователя

Страница: 12 / 28

12
Note: Your UltraComfort power lift chair can be stopped at any time
during lift or recline by releasing the selected button, offering you a wide
range of comfortable positions.
Select the position that best suits your needs. The motor is set to shut off
when it reaches its fully extended or fully retracted position if the selected
button is not released. If you should go past your desired position, select
the button to bring you back to your desired position. You can repeat the
process as often as you like.
Programming the Memory Buttons M1 and M2
1. Press and hold program button (M). The back light goes off while pressed.
2. In about 3 seconds the backlight will start flashing (one flash).
3. Within 5 seconds, press one of the memory buttons (M1, M2) to save the
position to the button pressed. The back light will return to non-flashing
position indicating that the new position is stored.
If a programmable memory button is not pressed within 5 seconds, or a non-
programmable button is pressed, then the programming sequence is aborted and
you will need to repeat steps 1 to 3 above. You may reprogram the memory
buttons as often as you like.
Factory Reset
Resets all the programmed buttons (M1 and M2) back to the factory settings.
1. Press and hold the down arrow (S2) until the motor stops.
2. Press and hold the cradle in arrow (S3) until the motor stops.
3. Press and hold the down arrow (S2) and the cradle in arrow (S3) at the same
time until the back lights come on, hand control is reset.
Note: Both motors need to be fully retracted (closed) in order to reset
the hand control.