background image

 

 

Owners Manual 

 MCS-100 Remote Control Motorcycle Alarm 

 
 

           

 

Important Note to the User

 

This equipment has been tested and found to comply with the limits for a class B digital device, pursuant to part 15 of the FCC Rules.  These limits are 

designed to provide reasonable protection against harmful interference in a residential installation.  This equipment generates, uses and can radiate 

radio frequency energy and if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.  

However, there is no guarantee that interference will not occur in a particular installation.  If this equipment does cause harmful interference to radio or 

television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one for 

more of the following measures: 

 

*Reorient or relocate the receiving antenna. 

*Increase the separation between the equipment and receiver. 

*Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. 

*Consult the dealer or an experienced radio/TV technician for help. 

This equipment has been certified to comply with the limits for a class B computing device, pursuant to FCC Rules.  In order to maintain compliance 

with FCC regulations, shielded cables must be used with this equipment.  Operation with non-approved equipment or unshielded cables is likely to 

result in interference to radio and TV reception.  The user is cautioned that changes and modifications made to the equipment without the approval of 

manufacturer could void the user's authority to operate this equipment. 

FCC ID:  MKYMT9207TX 

This device complies with Part 15 of the FCC Rules.  Operation is subject to the following two conditions: 

(1)  This device may not cause harmful interference and  

(2)  this device must accept any interference received, including interference that may cause undesired operation. 

 

Содержание MCS-100









Отзывы: