OUTPUT TO ACTIVATE SIREN (+) 2amp
GRAY
OUTPUT FOR TRUNK RELEASE (-)
OUTPUT TO ACTIVATE HORN/ AUX (-)
STARTER DISABLE (-) WHEN LOCKED
DOME LIGHT (-) WHEN DISARMED (30sec)
WHT/GRN
SECOND UNLOCK OUTPUT (-)
BLUE
N/A
GREEN
N/A
PURPLE
N/A
YELLOW
SWITCHED IGNITION INPUT (+)
WHT/BLUE
ORANGE
BLK/WHT
BROWN
WHITE
POSITIVE PARK LIGHT OUTPUT (+15amp)
SYSTEM CHASSIS GROUND INPUT
RED
CONSTANT 12 VOLT INPUT (20AMP)
BLACK
10 PIN CONNECTOR
3 PIN POWER CONNECTOR
FOR MORE DETAILED INFORMATION ON PROGRAMMING, WIRING DIAGRAMS, DOOR LOCK
CONFIGURATION AND OTHER INFORMATION, PLEASE VISIT
WWW.ULTRASTARTERS.COM
SYSTEM PROGRAMMING -
Menu 1
PAGE 6
KE-6
INSTALL MANUAL
SYSTEM WIRING
Pin 1- Brown Wire- SIREN Output (+) (2amp Maximum)
Connect this wire for optional siren activation.
Pin 2- Grey Wire- Trunk Release/Auxiliary Channel 2 (-250ma Output)
This output activates for 0.75 sec when the unlock button is held for 5 seconds.
Pin 3- White/ Blue Wire- HORN (-) / Aux Output (-250ma Output)
Connect this wire to the factory horn wire (-) type only. Output is programmable for an
auxiliary channel output.
Pin 4- Orange Wire- Ground When Locked (-250ma Output)
This wire switches to ground when the lock button is pressed. This output can be used
for a external starter disable or to activate such devises as a window roll-up modules.
Pin 5- Black/White Wire- Dome Light Supervision (-250ma Output)
This output activates for 30 seconds when the unlock button is pressed. Connect to a
relay to activate the interior lights or to the headlight circuit for illuminated entry.
Pin 6- White/Green Wire- Second Unlock Output (-250ma Output)
This output will activate when unlock is pressed twice with three seconds.
This wire can be used to install “Driver’s Door Priority” or to activate
Pin 7- Blue Wire- N/A
Pin 8- Green Wire- N/A
Pin 9- Purple Wire- N/A
Pin 10- Yellow Wire- Switched Ignition Input
12volt switch ignition input. Connect to the vehicles primary ignition wire.
Pin 1- White Wire- Park Light Output (+)
Connect this wire to the vehicles positive parking light wire. If the vehicle has a
negative or multiplex park light switch a relay must be installed to convert the output of
the alarm from positive to negative.
Pin 2- Black Wire- System Ground (-)
Using a self tapping screw, connect this wire to a solid section of the vehicles frame. If
required scrape away the paint to expose bare metal.
Pin 3- Red Wire- 12volt Power Input (+)
Connect this wire to a constant 12volt source such as the main 12volt power for the
ignition switch.
SYSTEM PROGRAMMING -
Menu 1
PAGE 7
KE-6
INSTALL MANUAL
SYSTEM WIRING
