5 Times
Self Learning Shock Sensor
4th Channel Output
5th Channel Output
Ignition Auto Locks
Starter Disable
2nd Car
1) Press the
LOCK
button on the remote 5 times, once every second. The siren
should chirp 3 times and parking lights will remain “On”
Note:
Timing is important to enter Shack Sensor Learn Mode. The lock button
must be pressed once every second 5 times.
2) After parking lights are on steady, strike the vehicle with a impact at the desired
level to trigger the alarm. (Impact the vehicle at least 3 times)
3) The siren will respond with a chirp to confirm each impact, press the lock or
unlock button to exit learn mode then test sensitivity.
This optional output can be used to activate additional alarm accessories.
1.Press and hold button #3 for two seconds.
2.The park lights will flash and the siren will chirp one time.
3.The optional feature will activate.
This optional output can be used to activate additional alarm accessories.
1.Press and hold the LOCK
and STAR
buttons for two seconds.
2. The
park
lights
will
flash
and
the
siren
will
chirp
once.
3. The optional feature will then activate.
sec.
2
Press Once to Lock Doors. Continue to hold for Panic Mode.
Press 2nd Time & Hold for Constant Lock Output
Press Once for Unlock Doors and Disarm the Alarm.
Press & Hold for Trunk / Aux Output
Press to activate the 4th channel output
Press & Hold for 3 seconds while running to turn off
Press & Release then hold for Service Mode (Valet Mode)
2nd Car Operation - See Dealer For Details
=
=
=
=
&
&
&
&
&
Dual Car Operation allows a single transmitter to operate the system in more than
one vehicle. Both vehicles must be equipped with an Ultra Start Alarm or Remote
Start system. To operate the second car’s features press the transmitter buttons as
follows.
Note:
The Buttons must be pressed at the same time.
The system has an optional starter disable output that can be connected by your
dealer. When the starter disable relay is installed and connected to the system, the
vehicle’s starter will be disabled when the system is armed.
To activate
the starter disable press the lock button on the remote.
The system will arm and the starter will no longer operate.
To deactivate
the starter disable, press the unlock button and the LED will stop
flashing and the starter will be re-enabled.
Optional Programmable Feature
- This feature will automatically lock the doors two seconds after the ignition key is
turned to the “On” position.
- The doors will unlock when the ignition key is turned to the “Off” position.
Ignition
On/Off