Installation Guide
OTHER FEATURES
Step 1
- Within three seconds turn the ignition Key ON-OFF-ON-OFF-ON -
Leaving Key ON
Step 2
- Press and hold the Program Switch - Parking Lights will come ON **if park-lights do not come
on at this point, turn key off for 5 seconds, the repeat step 1.
Step 3
- Continue to hold the Program Switch until park lights go out.
Step 4
- Press the
LOCK
button on each of
1st car
remotes and press the
#
button on each of the
2nd
car
remotes of the transmitters to be programmed. The park lights will flash once and the horn
will honk once each time a new code is learned.
Note:
Transmitter programming must done quickly. Do not pause more than one second between each
transmitter.
All the transmitters
to be used must be programmed at the same time.
All transmitters
not programmed at this time will be erased from memory for security. The system holds a
maximum of 3 transmitter codes including 2nd car remote codes.
You can program the same remote as a 1st car remote in one vehicle and as a 2nd car remote in a
second vehicle.
ACTIVATING Service Mode
1. While the ignition is “ON” press and hold the Program Button for five seconds. The
park lights will flash five times and the horn (optional)will honk five times to confirm
that the system is in Service Mode.
2. While in Service Mode the remote start functions will be disabled and LED’s will be
“ON” steady. Door locks and trunk release are still operational.
DEACTIVATING Service Mode
1. While the ignition is “ON” press and hold the Program Button for five seconds. The
park lights will flash two times and the horn (optional)will honk two times to confirm
that the system has exited Service Mode.
2. Remote start functions will return to normal operation.
+
-
Step #1 Step #2
Step #3 Step #4
Carefully remove the
screw from back of
the remote.
Remove top case
then replace the
battery.
Replace top case.
Re-install screw.
Test remote for
proper operation.
The transmitter battery should be changed at least once every year to maintain proper operating range.
Replace with quality23A 12volt Alkaline battery.
Transmitter Programming
System Service Mode(Valet Mode)
System Service Mode(Valet Mode) - By Remote
ACTIVATE Service Mode
1 - Press & Release button 4
2 - Press & Hold Button 4 for 6 seconds until Status LED comes on Steady
NOTE: If horn is connected the horn will chirp 5 times.
DEACTIVATE Service Mode
1 - Press & Release button 4
2 - Press & Hold Button 4 for 6 seconds until Status LED turns off.
NOTE: If horn is connected the horn will chirp 2 times.
11