3
a) If you can’t easily locate the “eye”, use a flashlight to shine light
through the front panel of the components; the eye is a small red
disc, approximately 1/8’ in diameter.
6. Once located, remove the adhesive tape cover from the emitter’s
clear tape and attach one IR Emitter to the IR “eye” of each A/V
component to be controlled.
a) Note that these are dual emitter cables so that two components
can be controlled by each cable (four cables included).
7. Connect the power supply to the IR Repeater box and then insert
the plug end into any standard 110-240VAC outlet.
8. Verify operation by turning your system components ON using your
existing IR remote controls.
Using the Hidden IR
Instead of aiming at your equipment, point the remote to the IR receiver
and use as you would normally.
The LED light on the IR Receiver will blink when you use your remote
control(s), confirming the system is working properly.
Содержание U12-41498
Страница 1: ...IR Repeater U12 41498 USER MANUAL...
