Activate
Chapter 5: Operating Instructions
Page 5-34
VersaMux-4000 Operation & Installation Guide
Part No. 24001157
Revision C
Activate
NOTE:
Two VersaMux units connected end-to-end must have matched aggregate rate and
port rate configurations.
The
Activate
parameter enables you to make the “offline” configuration or “undo”
configuration active.
Selecting the
Activate
parameter enables you to access the
Configuration
(to
activate) confirmation parameter. The (
Activate
)
Configuration
parameter
options are:
•
No
- Selecting this option exits back to the
Activate
parameter
(prompt) without making any changes.
•
Offline
- Selecting this option activates the offline configuration (see
for a description of the offline configuration
parameters). This makes the “offline” configuration the “active”
configuration.
•
Undo
- When you activate an offline configuration, the VersaMux
system stores the previous configuration in “undo.”
When you select
Undo
, the system copies the configuration stored in
undo to the active configuration.
For example, if you have an original active configuration that you
replaced by activating the offline configuration, you can restore the
original configuration by selecting
Undo
.
describes the
Activate
options and actions the VersaMux performs
when you select them.
Table 5-10
Activate Options and Actions
Option
Action Description
No
The VersaMux cancels the activation and does not make any changes.
Offline
The VersaMux copies the Active configuration parameters to the Undo configuration,
and copies the Offline configuration parameters to the Active configuration. The
VersaMux then re-initializes using the “new” Active configuration parameters.
Undo
The VersaMux copies the “Undo” configuration parameters to the Active configuration.
The VersaMux then re-initializes using the “undo” Active configuration parameters.
