3
1) SUPPORT ASSEMBLY OF LOWER LOOP ELEMENTS
The lower element of the loop is supported by an aluminium square section 60x60mm
placed directly below the motor unit.
It is fixed to the boom by means of two aluminium plates "
A
" (fig.1)
Assemble the plates to the sides of the boom with 6 M6-bolts
Insert the "
B
” square section to form a T, tighten the tube so that it remains in place.
Check with a set square to obtain a 90 ° angle (Figure 2) and tighten all bolts.
The plates will behave like a clamp and will maintain stability of the entire lower support.
Fig.1
Fig.3
Fig.2
The lower elements of the loop are installed on a plate similar to the motor supports (fig.3)
Install the aluminium support at the lower end of section "
B
" (fig.2). Check angle 90 °
before tightening the bolts.
Install the resin glass tube "
C
" with exactly the same procedure as used at the motor
units (See "Standard" manual).
C Support will keep the lower elements perfectly parallel to the upper ones, fixed to the motor
unit.
90°
B
A
C
