33
GB/MT
Dispose of the device if the
cable is damaged.
Initial use
Place the product on a level, non-flammable
surface. Do not cover the vents. Do not operate
the device in dusty environments. Doing so
poses a fire hazard and could damage the de-
vice.
For inflatables with counterpressure (e.g. partly
filled car tyre): Switch on the product before
connecting the connection valve
7
to the tyre.
Note:
Depending on the inflatable you can
use the connection valve
7
directly or along
with the included valve adapter
10
(see Fig. A).
Connecting to the cigarette lighter socket:
Note:
Verify the socket of the cigarette lighter in
your vehicle has an adequately sized fuse.
Verify the product is switched off: on / off switch
6
to position „0“.
Plug the cigarette lighter plug
5
into the socket
of the 12 V cigarette lighter.
Connecting the connection valve
7
:
Open the connection valve
7
: clamping
lever
8
vertical (see Fig. B).
Connecting without valve adapter
10
:
- Insert the open connection valve
7
into the
valve of the inflatable (if necessary, first remove
valve cover of the inflatable).
- Hold the connection valve and close: push
tensioning lever
8
toward connection valve
7
.
Connecting with valve adapter
10
:
- Push the respective valve adapter into the
opening in the connection valve
7
.
- Secure the valve adapter into the connection
valve
7
: push clamping lever
8
toward
connection valve (see Fig. C).
- Insert the valve adapter
10
into the valve on
the inflatable (if necessary, first remove valve
cover of the inflatable).
Switching on / off:
Switch the device on: on / off switch
6
to
position „I“.
Once the desired filling pressure has been
reached, switch the device off: on / off switch
6
to position „0“.
Remove the cigarette lighter plug
5
.
Removing the connetion valve:
Connecting without valve adapter
10
: Open
the clamping lever
8
for the connection valve
7
and remove from the valve of the
inflatable.
Connecting with valve adapter
10
: Remove the
valve adapter from the valve of the inflatable.
Open the clamping lever
8
of the connection
valve
7
and remove the valve adapter
10
.
Note:
Air may escape from the valve of the inflat-
able when removing the connection valve
7
. Be
sure not to remove the connection valve
7
too
quickly.
The manometer
2
is not calibrated. Therefore
seek a specialist facility with a calibrated de-
vice after inflating inflatables where incorrect
pressure can be dangerous (e.g. car tyre).
Operation
Working instructions
This product is not suitable for continuous operation.
It was developed to produce air pressure, not air
volume.
Do not use the product for longer than 5 minutes
without interruption to prevent overheating and
damage to the device. Afterwards allow to
cool for a minimum of 20 minutes.