ULTIMATE SPEED UMAP 12000 A1, Перевод оригинальной инструкции по эксплуатации и безопасности

Страница: 12 / 33

12 GB/IE/NI
Using the device
Note: An undervoltage protection circuit
is installed in the portable jump starter with
power bank
1
to protect the device from
damages. This prevents a deep discharge of
the portable jump starter with power bank
1
and automatically switches the device off
once the battery is fully discharged. Shortly
before the undervoltage protection circuit
becomes active, the last blue indicator light
8
starts flashing. As soon as the under-
voltage protection circuit is active, the last
blue indicator light
8
flashes and no more
energy can be obtained. Please re-charge
the portable jump starter with power bank
1
.
z
Using the jumpstart feature
„ „
When using the jumpstart, make sure
that at least 3 indicator lights
8
are
permanently illuminated.
Step LEDs Meaning / Error Solution
1. Connect the jumper
cable
10
of the
portable jump starter
with power bank to
the vehicle jumpstart
outlet
9
of the
portable jump starter
with power bank
1
.
Red Error LED
13
is
continuously lit on the jump-
er cable
10
.
The voltage
determined in the
portable jump starter
with power bank is
not enough to start
the car.
Charge the
portable jump
starter with
power bank.
Green Start LED
12
and
the red Error LED
13
flash
alternately.
Portable jump starter
with power bank
ready for operation.
Carry on with
step 2.
2. First connect the red
battery clamp (A) to
the positive pole of the
vehicle battery and
then connect the black
battery clamp B to
the negative pole
(see picture 1).
The red Error LED
13
flashes, a short alarm signal
sounds.
The temperature is
too high, possibly
due to several jump
start attempts.
First discon-
nect the black
battery clamp
(B) and then
the red clamp
(A) from the
battery poles.
Start again
with step 1.
The red Error LED
13
flashes, a continuous alarm
signal sounds.
Battery clamps (A)
and (B) are the
wrong way round.
It is caused by a short
circuit or the battery
is leaking.
The red Error LED
13
flashes
once, a continuous alarm is
sounded and then followed
by two short alarm sounds.
Green Start LED
12
and
the red Error LED 13 flash
alternately. After 1–2
seconds only the green LED
12
glows.
The connection is
correct
Carry on with
step 3.
3. Starting up the
vehicle.
322269_Mobile_Autostarthilfe_mit_Powerbank_UMAP_12000_A1_content_GB-IE-NI.indb 12 16.05.2019 13:24:41