ULTIMATE SPEED 351562 2007, Инструкции по эксплуатации и безопасности

Страница: 22 / 273

22 GB/IE/NI/CY/MT
switch 4 to the “1” (ON)
position. You will hear a short
beep and the overload display
3
(red) lights up briefly. After
that the operating LED 2
(green) lights up, if the car
power inverter
1
is properly
connected to a charged
battery.
„
Now switch on the load/
device to be operated.
Note:
If you hear a beep and the
overload display
3
lights up red,
the input voltage is too low, or
output of the load/device con-
nected to the car power inverter
1
is too high.
z
Instructions for
operating devices
General notes:
Information about the power
consumption in Ampere (A) or the
power draw in Watt (W) is usually
shown on the rating plate of
devices. Before using the device,
please make sure that the maxi-
mum current draw is not higher
than 1.30
A and the maximum
continuous output is not more than
300 W.
„
Loads with a high internal
resistance can be operated
very effectively using the car
power inverter
1 , whereas
loads with a low internal
resistance, such as, for
example, heating and cooking
devices, generally have a
power draw in Watt which is
too high.
„
Inductive loads such as, for
example, televisions or stereo
devices (devices with a coil or
a transformer) often require a
start-up current which is many
times higher than resistive
loads with the same given
power draw in Watt. When
switching on, televisions
require a power draw which is
many times higher than the
value given on the rating plate.
Instructions for operation
351562_2007_Spannungswandler_content_LB8.indb 22 351562_2007_Spannungswandler_content_LB8.indb 22 13.11.20 16:21 13.11.20 16:21