ULTIMATE SPEED 300487, Сборка и рекомендации по безопасности

Страница: 6 / 24

5 GB
TYRE STAND
˜
Introduction
We congratulate you on the purchase of
your new product. You have chosen a high
quality product. Familiarise yourself with the
product before using it for the first time. In
addition, please carefully refer to the operating
instructions and the safety advice below. Only
use the product as instructed and only for
the indicated field of application. Keep these
instructions in a safe place. If you pass the
product on to anyone else, please ensure that
you also pass on all the documentation with it.
˜
Intended use
The tyre stand is intended for the storage of
wheel rims with or without tyres. This product is
not intended for commercial use.
˜
Description of parts
1
Central linking piece
2
Spring washers x 4
3 Screws x 4
4 Down rod section (without plug)
5 End rod section (with plug)
6 Extension legs x 4
7 Plate x 4
8 Integrated pin x 4
9 Tread depth gauge
10 Air pressure gauge
11 Tyre protection cover
12 Tyre chips x 4, 4 different colours
13 Hexagon wrench
˜
Technical data
Suitable for all currently available car rims up to
18 inches (approx. 46 cm).
Suitable for all common car wheel rims with tyre
widths up to 225 mm (225/55 R18).
Material: steel, aluminium,
PP (polypropylene)
Total height: approx. 1 m
Weight
(without accessories): approx. 2.4 kg
Max. load capacity: 100 kg
Max. load per plate: 25 kg
˜
Accessories
Tyre protection cover
11
With hook-and-loop tape fastening
Tyre chips
12
In 4 different colours.
Labelling: front left, right front, left rear, right
rear
Air pressure gauge
10
For easy measurement of air pressure.
Measurement range: 0.7 – 3.5 bar /
10 – 50 psi
Tread depth gauge
9
Measurement range: 0 – 20 mm; shows
statutory minimum tread depth (1.6 mm) and
recommended tread depth for winter tyres
(4 mm).
The required profile measurements may vary
by country. Therefore please find out about the
specific regulations in your country.
Safety information
Do not tilt the tyre stand!
WARNING! RISK OF INJURY TO
PERSONS! DANGER OF TIPPING!
Place the tyre stand only on a level, flat
and solid surface. The base must not slope,
as the stability of the rack cannot then be
guaranteed (use spirit level to check)!
The tyre stand may not be used for any
other purpose since this could cause injury.
The tyre stand may not be moved when
supporting a load (rims + tyres) since there
is a danger that it could tip over.