Ultimate
5
2.
Flush Mount-
Using the flush mount housing as a template, mark the cut-out hole in
the mounting surface carefully. The exact size of the hole should be 2 1/8”(53.8mm), and
it will be difficult to hide any mistakes. Cut out the mounting hole. Slide the tweeter into
the flush mount housing. Push the hex head machine screw through the center hole in the
bottom plate from the side with the hex recess. Make sure the screw head is seated in the
recess so it will not turn. Feed the wire leads through the exit hole in the bottom plate.
Press the bottom plate into the bottom of the flush mount housing and turn it to lock it in
place. Feed the wire leads through first, then press the entire assembly through the cut-out
hole in the mounting surface. Press the retaining clip onto the machine screw, and
tighten the hex nut on the screw until the entire assembly is firmly in place. Do not over
tighten. Connect speaker wire from the crossover
T+
and
T-
terminals to the tweeter lead
wires, observing correct polarity.
Specifications
Model
PS65
PS52
Size
6.5"/165mm
5.25"/133mm
Impedance
4
Ω
4
Ω
Frequency
50Hz-25kHz
70Hz-25kHz
Sensitivity
92.5dB
92dB
Power- RMS
80 Watts
65 Watts
Power- MAX
160 Watts
130 Watts
Cone
HEATT
HEATT
Surround
Butyl
Butyl
Tweeter
Titanium
Titanium
Frame
Black Chrome
Black Chrome
Magnet Cover
Rubber
Rubber
Crossover
2-Way, 12dB/Octave
2-Way, 12dB/Octave
Mounting Depth(In.)
2.6"
2.2"
Mounting
64mm
54mm
See the supplied warranty card for service information
Call 888-909-9988 for technical assistance.
I. Introduction
