Ultimate Products AL, Руководство пользователя

Страница: 21 / 58

2319 Laurelbrook Street, Raleigh, NC 27604 · (800) 542-7221 · FAX (919) 834-4526 · www.ultimate-products.com
- 20 -
USER INSTRUCTIONS
ULTIMATE PRODUCTS TUBULAR RADIANT HEATERS
Ultimate Products is the distributor of a series of tubular infrared heaters
designed for overhead heating of industrial and commercial buildings. Individual
heating units are suspended from the roof or mounted at an angle on the wall
when inside buildings or horizontal when outside.
IMPORTANT
1. This appliance must only be installed by qualified craftsman in accordance
with the requirements of local and national codes.
2. This appliance must be grounded in accordance with the National Electrical
code ANSI/NFPA No.70.
3. Never rest anything, especially ladders, against the heater.
TO START THE HEATER
1. First ensure that the gas supply to each heater is turned on by opening main
gas shut-off valve and manual valve on combination control.
2. Ensure that the settings of any time switch and thermostat are such that the
heating system will be required to operate.
3. Switch on the electrical supply to the heater. The fan will start, the “Power On”
light on the burner will illuminate and ignition will commence.
4. Ignition will occur and the burner light, colored orange, will illuminate.
5. If ignition is unsuccessful the gas valve will close and the spark igniter de-
energize after approximately six (6) seconds. For approximately 10 to 20
seconds the fan will purge the system then re-ignition will be attempted. After
three (3) attempts at ignition the control unit will lockout, the “power-on” lamp
will remain illuminated and the fan will continue to run. To reset after
“lockout”, switch off the power supply to the heater and wait 5 minutes. Then
turn the power on. If repeated “lockout” occurs investigate the cause.
TO SWITCH OFF THE HEATER
Switch off the electrical supply. The burner will shut off and the fan will stop.