ULTIM8 FITNESS Active8, Руководство пользователя

Страница: 12 / 15

HOW TO SPRAY SILICONE ON DECK
1). Find the silicone bottle. It put into hardware kit package when you purchase this treadmill, and open
the carton box.
2). Find a straw and put on silicone bottle as the drawing showing.
3). Spray silicone on treadmill deck even, the spray area is like the drawing showing.
(
ATTENTION : You must stop the treadmill belt completely before spraying the silicone. Failure to do
so could cause injury such as cutting your hand on the edge of the belt and crushing your fingers
between the rear roller and the belt.)Do not put too much silicone on the deck. It can cause the running
belt to slip when in use if there is too much lubrication.
CLEANING
Perspiration should be wiped from the console and treadmill surface after your workout. You
should wipe down this treadmill after each use with a water dampened, soft cloth. Be careful
do not get excessive moisture on the display panel, this might cause an electrical hazard or
electronics to fail.
STORAGE
Store your treadmill in a clean and dry environment. Ensure the master power switch is off and
is unplugged from the electrical wall outlet.
MOVING
This treadmill has been designed and equipped with wheels for easy mobility. Before moving,
ensure the master power switch is in the off position and the power cord is unplugged from the
electrical outlet.
FOR CONSUMER/HOME USE ONLY
This treadmill is designed for home use only. Do not use for light institutional or commercial.
TROUBLE SHOOTING
SYMPTOM CAUSE
SOLUTION
Console display LED's do
not illuminate
A).No power to treadmill.
B).Console wire is not
connected or incompletely.
C).Overload, protecting is
started.
Check the on-off switch
turn off, then turn on power. Put
START, if still not illuminate,
service required
Scrambled digitalis on console
LED Damaged console
Service required