Ulma 3000 TCA, Руководство по установке и обслуживанию

Страница: 4 / 23

4

Description
Ulma3000 TCA is intended to be mounted on a boiler and shall be fueled with 6-8mm wood pellets. The
enclosed conveyor feeds the fuel from a separate storage. The integrated PLC steering controls the burner
via the temperature giver that starts and stops the burner automatically. The burner has a switch for on-and-
off switch that sits on the right side of the burner. The burner is provided with a PLC system that controls the
supervision and controls the combustion. The burner is ignited with help of a hot-air heater when the boiler
temperature goes below the pre-set thermostat setting. The start procedure is fully automatic in several steps
to get a fast and almost smoke free ignition. To then stop completely when set max temperature has been
reached. After a short cooling phase the burner stops and re-starts when the thermostat calls for more heat.
Construction
The construction and choice of material are made with a long life time in mind. The firing zone of the burner is
made of stainless, acid proof and high temperature constantly steel. The burner is an overflow fed kind of
burner and equipped with compressed air cleaning.
Pellet break
In the lower part in the fall shaft we have placed a ”cat door” that works as a break and place the fuel on the
right place in front of the ignition element. The end-stop also works as a pellet break in the front edge of the
burner pipe.
Safety functions
Ulma3000 TCA fulfills all existing safety requirements and norms according to the Swedish National Housing
Board. The burner is equipped with several, of each other independent, safety functions.

The overheating protection on the tipping chute that turns off the burner when the temperature goes
over 70°.

The flame guard that has the supervision of the flame.

The fall shaft that prevents contact between pellets and combustion.

A third safety detail is the plastic feed hose between feed auger and burner. The hose melts off at too
high temperature and thereby cuts off the pellet feeding to the burner.
Unpacking
At unpacking of the burner, make sure that all parts on the list below are there:
1. Pellet burner Ulma 3000 TCA
2. Installation and maintenance instructions
3. Fall hose with hose adapter
4. Kit with mounting set (mounting chain)
5. 2 screws for mounting of tipping chute
6. Metal inlet
Mounting of tipping chute
Cut off the bundle band and fasten the tipping chute
with screws in suitable angle.
N.B.! Be careful with the cables. See picture to the
right.