signals / functions you are interested in work in the app by trying
them in the car. For example, if you activate the headlight on the
car, HIGHBEAM should change the status to ON and be marked in
green. The same applies to other signals. If you want to try another
recipe, click on it
•
IMPORTANT!
Finish the installation by switching of and lock your
car. Then check in the app if the signal SYSTEM_ACTIVE listed. If so
it's important that SYSTEM_ACTIVE gets highlighted with red color
(0/AV/OFF) 2 minutes after exiting and locking your car. If
that
doesn't
happen the selected recipe isn't compatible with your
car and there's a risk of draining the battery. Please try a different
recipe.
•
before you contact our support!
XBB PowerUnit® installation
•
Install the XBB PowerUnit® in your car, you can find wiring
examples
Important! Make sure that negative cable (GND) is connected to
the correct pin on XBB PowerUnit®, especially if you're using a
premade cable harness!
Note! When placing the XBB PowerUnit® it's important that it's
mounted in an upright position with the contacts downward,
otherwise it may take in water.
•
The next step is to add your XBB PowerUnit® in the app.
•
If you still have the app running, just press PowerUnit or swipe left
to get to the XBB PowerUnit® page. If you have taken a break during
the actual installation, you must search for your XBB Dongle® again
to access the menu. If it has also been more than 10 minutes since
you were connected to your XBB Dongle®, you need to pull it out
and insert it again in the diagnostic socket and it will be visible to
the phone again.
•
When you are on the PowerUnite page, press
add
button in the
lower right corner and select "Add PowerUnit", then select the XBB
PowerUnit® that appears.
•
Then press
settings
(Settings) to configure your XBB PowerUnit®
•
Select in the list which signal you want Output 1 (15 amps or 180W
@ 12V) to follow. Is it the usual headlight you want it to follow, you
should generally choose HIGHBEAM.
