GUITAR TECH INSTALL ONLY
CAUTION
SCRATCH PLATE
Single coil pickup noise is FINALLY SOLVED without any change in pickup
tone. Easy fitment with no drilling, gluing required. Simply two solder
joints. Ideally fitted to a guitar with all pickups the same polarity (with-
out a reversed wound middle pickup).
STEP 1. Remove scratch plate mounting screws to gain access to body control
routing. De-solder the black pickup leads from the back of the volume pot.
Twist these wires together and solder to either wire of the NRS module.
The other end of the NRS wire is soldered to the back of the volume pot where
the black pickup wires were previously soldered.
STEP 2. Holding the scratch plate with pickups vertically, plug guitar into an
amp and turn up the guitars volume. One of your hands must be touching an
earth point (scratch plate shielding, bridge, or back of pots etc).
STEP 3. Holding the NRS module flat to the scratch plate you will notice that the
standard single coil noise is reduced when the NRS is flipped 180 degrees. FIG 1
With the noise reduced mark the dot on the inner face of the NRS with an arrow
pointing towards the scratch plate so as to be able to install the NRS module
into
the control cavity keeping the correct orientation of the NRS during final
assembly.
FIG 1
