13
BEFORE USE
[Figure 1] - Install one AA battery.
[Figure 2] - Lithium-ion battery charger
input.
[Figure 3] - 20LB Propane Tank Cover.
IGNITION BATTERY
1. Install one AA battery for the electronic ignition located inside
of the unit (AA battery included). Begin by carefully flipping the
unit upside down, and unscrew igniter battery compartment cap
counterclockwise. Insert battery with positive side facing out, then
tighten igniter cap back on (make sure the battery is installed the
proper direction). [Figure 1]
CHARGING THE AUDIO BATTERY
1. Before using your Ukiah Co. audio system, fully charge the lithium-
ion battery by plugging the charging cable provided into the charging
port on the unit. [Figure 2]
• The LED INDICATOR on the charger will turn RED when the battery
is charging.
• The LED INDICATOR will turn GREEN when the battery is fully
charged.
The battery will take up to 6 hours to fully charge and will run for
up to 20 hours on a single charge. The unit can be operated while
connected to the charger. The internal battery powers the audio
system only and is not needed for “Fire Only” mode.
WARNING — Charge the battery by using only the original
charging cable supplied. Using another charging cable may harm the
battery.
LAVA ROCK/GLASS MEDIA
1. Open the box of included glass media and carefully place in the
burner tray, making sure not to cover the screen that protects the
ignition system or the holes of the burner. Lava rocks may be used in
place of the glass media (lava rock not included).
PROPANE TANK COVER
1. Slip the propane tank cover down over the tank. Once covered,
tighten the top and bottom pull cords to secure to tank. [Figure 3]
