4.
The safe operation of the filter is only guaranteed if the installation and operation
instructions are correctly followed.
5.
To reduce the risk of injury, do not permit children to use this product.
6.
Chemical spills and fumes can weaken your Swimming Pool or Spa, cause corrosion to filters
and other equipment failure, resulting in severe injury or property damage. Do not store
pool chemicals near your equipment.
7.
Any modification of the filter requires the prior consent from the supplier and original
replacement parts and accessories authorised by the manufacturer, to ensure a high level of
safety.
Sand Filtration working principle
Incoming water from the swimming pool piping system is automatically directed by the
Multiport Valve to the top of the filter bed and filtered out. The filtered water is returned from
the bottom of the filter tank, through the Multiport Valve and back through the swimming pool
piping system.
Preparation before installation
1.
Position the filter as close to the Swimming Pool/Spa as possible.
2.
The filter should be placed on a level concrete slab, very firm ground or the equivalent.
Ensure that the ground will not subside, preventing any strain on the attached plumbing.
3.
Position the filter so that it does not compromise the piping connections, ensuring
convenient operation and servicing.
4.
Ensure that the compliance label is facing the front to allow easy identification in the case of
service difficulties.
INSTALLATION OF FILTER TANK
1.
Place the filter tank on the base, locate the two front lugs at the foot of the filter into the
base first, then lower the filter flat onto the back of the base. Then simply twist the tank
clockwise to locate the four lugs fully home into the base slots (see fig 1.) If installed
correctly you should not be able to lift the tank off the base at this point. Please ensure you
position the outlet drain plug so that it is facing front and centre for ease of operation.
Fig. 1
