ujk technology 506300, Оригинальное руководство пользователя

Страница: 15 / 28

UJK Dovetail Jig Processes
15
0.1
Fig 18
router. Sit the router on the jig so that the cutter goes
between and will be supported by the template comb
and extraction bar. Start on the left hand side of the jig,
start the router and gently push forward through the
workpiece, the guide bush will follow the profile of the
template, see fig 18. Do not force or push the router too
hard as this will brake out the back edge of the timber
when the cutter breaks through. Work along the
template (left to right) cutting each part of the joint.
When the cutting is complete, switch off the router and
ensure that the cutter has stopped spinning before you
remove the router from the jig.
15. With the router removed check that the joint has all
been cut and that there are no bumps or uncut parts, see
fig 19-20.
0.1
Fig 19-20
WORK FROM LEFT TO RIGHT.
Setting the Cutter Height for ‘Pin’ Boards
16. Unplug the router. On the left hand side of the jig
is an adjustable depth stop wheel, this can be used for
setting up the cutter height for cutting the ‘Pin’ board.
To use this, place the ‘Tail’ board in the horizontal position
in the jig and lock in place with the eccentric bar clamp.
Adjust the height of the comb so that this sits evenly
across this board, then lock off comb bar by tightening
black star knobs. Place the router with the dovetail cutter
onto the comb so that the cutter and guide bush are
located in the side recess cutout,see fig 21. Adjust the
depth stop wheel so that this top face of the wheel meets
the cutting tip of the preset dovetail cutter, ( this being
set at same height as used to cut ‘Tail boards). Lock this in
place with locking nut, see fig 22.
0.1
Fig 21-22
Side recess cutout
Guide bush
Nip up the locking nut
Depth stop wheel
17. Change the guide bush to the 5/8” diameter and
swap the cutter to the 10.39mm straight cutter, (follow
guide instructions as in (step 11). Reposition the router
on the side recess cutout location, set the tip of the
straight cutter down to the top of the preset depth stop
wheel, see fig 23.
Note: If all the tail boards are the same width these
can all be cut at this stage.
0.1
Fig 23
Guide bush
Straight cutter
Continues Over....