UJK Dovetail Jig Processes
12
(Chapter 0.1)
Process for Through Dovetail
1. Select the through dovetail and finger joint comb, (E).
Bolt this onto the comb bar support brackets (B) using
the four countersunk hex screws (J) making sure that
engraved wording of ‘Tail /Box’ is facing the front of the
jig, see fig 01 (see parts list on page 3).
0.1
Fig 01
Dovetail joint guide
Marking guage
0.1
Fig 02
Hex screw
2. Whilst the comb bar assembly is removed from the jig,
on the left hand side of the jig, slacken the Hex screw
that hold the side stop location bracket. Slide the bracket
as far left as possible and gently re-tighten hex screw, see
fig 02.
0.1
Fig 03-04
3. To help set up the cutter depth it is worth using a
cutting gauge. Scribe a depth line across the end of the
boards, use the boards to set the cutting gauge up, take
one jointing corner, set the gauge to the thickness
of one board, see fig 03. Once the gauge is set, mark this
depth across the end of the other jointing board, see fig
04. It is also worth labelling the boards, the ‘Pin’ boards
being the front and back of a drawer and the ‘Tail’ boards
being the sides.
4. Locate the Comb bar assembly onto the jig, check the
legs of the comb bar support brackets are fitted between
the black star knob (A) and the brass depth adjustment
wheel (B), and that the correct template comb is facing
forward toward the front of the jig, see fig 05.
5. Position the board within the jig, the ‘Tail’ board
(drawer sides) being cut first. These need to be loaded
into the vertical position, with scribe line facing towards
the user, see fig 06.
Scribe line
0.1
Fig 05
A
B
0.1
Fig 06
Pin
Tail
Tail
Tail
Cut Tails First
Scribe line
Содержание 506300
Страница 26: ...Exploded Diagram Parts List 26...