Check mode 2: Foil
Connect a foil to a body cord on the right side of the tester. The crocodile clip for connecting
the vest can be attached to the conductive fabric part at the top of the device. Press the
button on the device and hold it down until the middle mode LED lights up red. Release the
button now.
The lower measuring LED signals the resistance of the foil. The LED lights up
green for a resistance <= 3.0 Ohm
yellow for a resistance between 3.1 ohms and 5 ohms
red for a resistance between 5.1 ohms and 10 ohms.
The LED does not light up if the resistance is> 10.0 Ohm.
In addition, a resistance> 3.0 Ohm is indicated by an acoustic signal.
If the upper measurement LED lights up red, a connection between the foil and the vest
connection was briefly established. This signaling remains visible until the measurements
are reset by briefly pressing the button
Check mode 3: Sabre
Connect a saber to a body cord on the right side of the tester. The crocodile clip for
connecting the vest can be attached to the conductive fabric part at the top of the device.
Press the button on the device and hold it down until the right mode LED lights up red.
Release the button now.
The lower measuring LED signals the resistance or micro-interruption of the saber. The LED
lights up
green for a resistance <= 3.0 Ohm
yellow for a resistance between 3.1 ohms and 5 ohms
red for a resistance between 5.1 ohms and 10 ohms.
The LED does not light up if the resistance is> 10.0 Ohm.
Micro interruptions are indicated by a red LED. The worst signaled value remains visible until
the measurements are reset by briefly pressing the key.
In addition, a change in resistance from <= 3.0 Ohm to > 3.0 Ohm is signaled once by an
acoustic signal.
If the upper measurement LED lights up red, a connection between the saber and the vest
connection was briefly established. This signaling remains visible until the measurements
are reset by briefly pressing the button.
