Ugur UDD 100 SC, Руководство по эксплуатации, Страница: 43 / 226

EN
C- INSTALLATION OF YOUR PRODUCT
Selecting the place of installation
The operating environment of the product is very important for the smooth operation of your product. While select-
ing the operating environment,
Do not place your product exposed to outdoor environment (on the street, avenue, etc.).
Be careful for not obstructing lower shutter of the product with materials such as cardboard, box etc. for a proper
cooling. (Picture 4)
Place the product at least one (1) meter away from heat resources (stove, radiator, electric heater etc.). (Picture 5)
Do not place it opposite to the air conditioner chutes, under fans and direct door and window openings. (Picture 6)
Do not expose to direct sunlight. Operation ratio will increase if sunlight comes to your product’s glass. That means an
increase in the energy consumption.
Air intake and outlet must absolutely be fluent and free for proper operation of the compressor section of your
product.
While approaching your product to the wall, be careful that there is a gap of 150 mm (15 cm) between the wall and
back of your product.
WARNING!
In very humid environments, ensure that floor and wall of the place where the device is located, is not affected by water;
against discharge water overflow danger.
In installations performed by Authorized Uğur Service, Authorized Uğur Service shall inform the consumer on the suitable
place for installation and make suggestion, but the consumer shall give the final decision on where the installation will be
made. This above mentioned process shall also be stated on the relevant installation form by Authorized Uğur Service. In
case of any loss arising from the place of installation of the product according to the final decision given by the consumer,
all responsibility related to such loss shall belong to the consumer.
Your product gives the best cooling performance according
to the climate condition under the conditions given below.
Therefore, be careful that the temperature of the environment
where your product will operate is at these levels.
Climate Class Temperature Range Humidity
Class 3 +16°C ile 25°C %60 Rh
Class 4 +16°C ile 30°C %55 Rh
Class 5 +16°C ile 40°C %45 Rh
Class 7 +10°C ile 35°C %70 Rh
Climate Class of your product is indicated on the technical specification label on the product.
PICTURE 5 PICTURE 6
PICTURE 2 PICTURE 4
43