Ugolini Deluxe 12L UL, Руководство оператора

Страница: 6 / 20

6
Arctic Deluxe 12-20 UL
front side (faucet side) up and off bowl gasket (see figure 2).
figure 2
3
Remove the bowl gasket.
4
Remove the pump impeller from its location.
5
Pinch tube faucet : push the dispensing handle (1) and
take the pinch tube off from its seat (2) (see figure 3).
figure 3
6
Gravity faucet: extract the piston and then remove the
dispensing handle (see figure 4).
figure 4
7
Slide drip tray out and empty it.
5. 3. 2 CLEANING
1
Prepare at least two gallons of a mild cleaning solution of
warm (45-60 °C 120-140 °F) potable water and dishwashing
detergent. Do not use abrasive detergent.
Important: if present, follow label directions, as a too strong
solution can cause parts damage, while a too mild solution will
not provide adequate cleaning.
2
Using a brush, suitable for the purpose, thoroughly clean all
disassembled parts in the cleaning solution.
3
Do not immerse the lighted top covers in liquid. Wash them
apart with the cleaning solution. Carefully clean their undersi-
des.
4
In the same manner clean the evaporator plates using a
soft bristle brush.
5
Rinse all cleaned parts with cool clean water.
5. 3. 3 SANITIZING
Sanitizing should be performed immediately prior to
starting the machine. Do not allow the unit to sit for
extended periods of time after sanitization.
1
Wash hands with a suitable antibacterial soap.
2
Prepare at least two gallons of a warm (45-60 °C 120-
140 °F) sanitizing solution (100 PPM available chlorine concen-
tration or 1 spoon of sodium hypoclorite diluted with two litres of
water) according to your local Health Codes and manufactu-
rer’s specifications.
3
Place the parts in the sanitizing solution for five minutes.
4
Do not immerse the lighted top covers in liquid. Carefully
wash their undersides with the sanitizing solution.
5
Place the sanitized parts on a clean dry surface to air dry.
6
Wipe clean all exterior surfaces of the unit. Do not use abra-
sive cleaner.
IMPORTANT
Do not attempt to wash any machine components in a
dishwasher.
ATTENTION
Before any disassembly and/or cleaning procedure make
sure that the dispenser is disconnected from its power
source.
IMPORTANT
In order to prevent any damages to the dispenser use
only a detergent suitable with plastic parts.
ATTENTION
When cleaning the machine, do not allow excessive
amounts of water around the electrically operated com-
ponents of the unit. Electrical shock or damage to the
machine may result.