11
(32°C) and drop below 32°F (0°C) for
optional functioning.
3. 2 OPERATING PROCEDURES
See if the cabinet door is opened and close
smoothly.
1
Remove a protective adhesive tape
from the drawer. And from rear panel set
free two wire in the suction tube. Install the
“Drawer” in the “Cabinet body”.
2
After inserting the power plug into a
dedicated 120 or 220 Volt power source,
turn on the power switch on the black
panel. You shoul hear2 “beeps” to signify
that the dispenser is receiving electricy.
3
Open the “Cabinet Door”. If the door is
open over 5 minutes, melody alarms you to
close the door.
4
Roll the “Drawer” out of the cabinet.
Remove a plastic seal from water bottle
and wipe rim, if desired, with a damp cloth.
Place a 5-gallon water bottle right on the
middle of the “Drawer” and roll back into the
“cabinet”.
5
Close the “Cabinet door”.
6
Then the “Suction tube” comes down
and the “pump” starts to supply water to the
hot and cold “water tank”
7
Turn on the “hot water switch” placed on
the black panel.
Please turn off the hot water switch onm the
back panel when not in use.
8
Allow 20 minutes for heating and three
and a half hours for cooling to the initial
setting temperature.
NOTE:
Melody will be heard the water bottle is empty
or when the door remains open for more 5
minutes. Then change a water bottle with a
new a new once or close the door correctly.
4 REPLACING THE BOTTLES
1
When a water bottle is empty, the empty
LED will start blinking and BT 18/7 will call
you with a melody.
