Ugin MINICAST, Инструкция по эксплуатации

Страница: 4 / 8

INSTRUCTIONS FOR USE MINICAST
12
INSTALLATION AND SET-UP
OF THE MINICAST CASTING MACHINE
1
-After unpacking the machine, verify its condition and notify the shipper and supplier
of any damage. Remember to have the deliveryman sign the shipping order on which
any reservations have been noted and to confirm the latter to the shipper by
registered letter with acknowledgement of receipt. .
2
-Set the machine on a flat surface and level it if needed .
COMMENT: The machine may also be bolted onto a table or bench top.
Necessary equipment
- 12 8 mm diameter nuts
- 12 8 mm diameter washers
- 4 8 mm diameter screw rods - Length depends on thickness of base.
Dismount the underside plate. Unscrew the four rubber pads and replace them with the
screw rods, held firmly in place with nuts and washers on either side of the frame plate.
Drill 4 holes in the table or bench top at a center distance of 644 mm x 450 mm.
Center the machine so that the screw rods on the underside fit into these holes.
Screw down the machine from underneath the table or bench top using 4 nuts and
washers
3
-Raise the cover and remove the arm block.
4
-After making sure that the mains voltage corresponds to that mentioned on the
identification plate, connect the power cord to a standard 10/16A plug with a grounding
terminal.