UGAS 86559, Инструкция по эксплуатации

Страница: 15 / 16

15
GB
U GAS
• Piezo push ignition
• Working temperature 1,000-1,200 °C
• Wrist support
DG number: DG-4027.
Special safety instructions
The roo� ng set may only be handled and
used outdoors in locations with good air
circulation.
Avoid modifying or repairing the roo� ng
set yourself, as this may involve serious
safety risks. Only use original accessories or
accessories recommended by the retailer.
Do not use the roo� ng set if it is damaged,
defective or worn.
Use soapy water to check that all
connections are sealed before use. Never use
a naked � ame to perform a leakage test.
Use an approved 5, 11 or 33 kg gas bottle.
The gas bottle may only be connected and
replaced in the open air. Do not smoke,
use a naked � ame or electrical equipment
while the gas bottle is being connected or
replaced.
The gas bottle must stand stable so that it
cannot tip over while the roo� ng set is in
use. The gas bottle must be upright with the
regulator facing upwards when in use.
Make sure the hose does not break or twist
when using the roo� ng set.
Keep the gas bottle at a safe distance from
heat sources during use. Make sure that
the gas bottle and hose do not come into
contact with the surfaces you are working
on.
Do not leave the roo� ng set unattended.
The burner and the area around it will get
very hot during use. Avoid touching these
parts and allow them to cool fully before
transporting or storing the roo� ng set.
Avoid inhaling smoke or fumes created as a
result of work.
The roo� ng set and gas bottle should be
stored out of the reach of children in a dry,
dust-free and well-ventilated location.
Note: If the roo� ng set is to be used in a
business context, hose-break protection
must be � tted so that the gas is automatically
and immediately turned off in the event of
the hose breaking.
Assembly
Connect the hose (9) to the regulator
(10) and burner (6). Carefully tighten all
connections. The hose (9) and connector
near the burner handle (6) are equipped with
a left thread, while all the other connections
are equipped with a right thread. Carry out a
leakage test using soapy water before using
the roo� ng set.
Use
Check that all the valves are fully closed and
the hose connections are completely tight.
If necessary, carry out a leakage test using
soapy water.
1. Attach the regulator (10) to the gas bottle
and open it.
2. Then open the regulator (10) and the
adjustment valve (4), press the gas
throttle in (8) and wait a moment until
the air has been forced out of the system.
3. Light the � ame on the burner (1) using
the built-in spark lighter (11) or a naked
� ame. Make sure not to touch the � ame
once the gas is lit with an external � ame
source!
4. Adjust the � ame using the adjustment
valve (4) while holding the gas throttle
(8) in. The � ame must not lick around
the burner head (1). Note that if the gas
bottle is brand new or if the gas burner is
cold, the � ame may be uneven, but this
will rectify after a brief time.