UFO MicroLED 1000P, Руководство пользователя, Страница: 4 / 8

4
UFO LIGHTING
INSTALLATION AND OPERATION
There are 2 connections required - the fibre port and the mains supply. The fibre port should be
connected first. Connect and secure the fibre optic connector into the front of the unit and
secure using the M5 locking screw.
Plug the mains plug into the electrical supply socket. Switch on the power, the LED indicator
will illuminate, and the light source will start up automatically. If no light is produced consult
the troubleshooting section of this manual.
Note that these light sources are not mains dimmable.
CONNECTION
The light source has 2 colour cycles, each with 3 different speed settings, the colours are
detailed in the table below:
OPERATION
Cycle Colour 1 Colour 2 Colour 3 Colour 4 Colour 5 Colour 6 Colour 7
1 White Red Orange Jade Green Cyan Blue
2 Pink Red Orange Jade Green Cyan Blue
The light source is controlled using the 2 push buttons on the rear of the unit.
The upper button stops and starts the colour cycle.
The lower button is used to select the cycle speed as follows:
Push the lower button repeatedly until the colour white is displayed. The light source is now in
Cycle 1 Speed A as detailed in the table below. Each push reduces the speed. On the third push,
the colour red will be displayed. The light source is now in Cycle 2 Speed A.
At any time the cycle can be stopped on a colour and started again using the upper push
button.
Cycle Speed A - Fastest Speed B - Slower Speed C - Slowest
1 (White Start) Push once Push once Push once
2 (Red Start) Push once Push once Push once