UFO LC20EN Flora, Руководство пользователя и сертификат гарантии

Страница: 30 / 40

10
Low Water Level Warning;
When water level in the tank is below Min., UFO Convector stops humidifying,then
warns the user visually by flashing “HUMIDITY ERR” and “drop” icons on the
screen, following an audible warning with a “beep” sound for 2 seconds long.
In this case, you can reactivate the humidifier by following the 3 steps described
below;
• Fill the tank with water to the Max. level.
• When the appliance is in “On” position, keep touching the “Humidifier”
button until all the related warnings disappear from the screen.
• Touch the “Humidifier” button again to reactivate the function.
CAUTION!
Do not activate the humidifier if the tank lacks water. When activated
without adding water, the appliance will detect the “low water level” and repeat
the warnings. Make sure that the water level is above “Min” before restarting the
humidifier function.
Cleaning:
Depending on the content of water used in the “Humidifier Tank”, lime or dirt
may build up on the resistance or inside the tank. See Chapter 5 ( Cleaning and
Maintenance) for cleaning instructions of the humidifier tank.
b. Setting the On-Off Timer (PRG Function)
UFO CONVECTOR can be programmed to operate at a defined time period. So that
it heats only during the programmed time.
Do not forget to set the correct time before activating this function. “PRG” function
operates depending on the time you set.
CAUTION!
UFO CONVECTOR heats only at the programmed time intervals when
“PRG” function is activated. Except this time interval, it will not operate even if the
room temperature is below the set temperature.
Touch the “PRG” button for 4 seconds when the appliance is in
“On” position.
PRG” and “ON TIME” icons start flashing on the LCD display.
Set the ‘on’ time by touching the “Arrow” buttons. The setting
speed can be increased by touching continuously.
When the ‘on’ time is set, touch “OK” button to save it.
Then “TIME OFF” icon starts flashing indicating that you
should set an ‘off’ time. Set the ‘off’ time by using the
“Arrow” buttons.
Save it by touching the “OK” button.
TEMP °C (or TEMP °F) will start flashing on the LCD screen.
Adjust the desired room temperature for this time interval
by using the “Arrow” buttons.
Touch the “OK” button to finish the programming.
“PRG” icon appears on LCD screen and tells you that the appliance is programmed
to operate for the set time only.
PRG
OK
OK
OK