UfiSpace S9700-23D, Руководство по установке оборудования

Страница: 31 / 32

S9700-23D Hardware Installation Guide | 29
Installation Location Statement
It is recommended that the device be installed only in a server room or computer
room where access is:
➢ Restricted to qualified service personnel or users familiar with restrictions
applied to the location, reasons therefore, and any precautions required.
➢
Only afforded by the use of a tool or lock and key, or other means of security,
and controlled by the authority responsible for the location.
Suitable for installation in Information Technology Rooms in accordance with Article
645 of the National Electrical Code and NFPA 75.
Cautions and regulatory compliance statements for NEBS:
•
“Suitable for installation as part of the Common Bonding Network (CBN)”
•
“An external Surge Protection Device (SPD) must be used with AC powered equipment
and that the Surge Protection Device is to be installed at the AC power service entrance.”
•
“System can be installed in Network Telecommunications Facilities where the Nat ional
Electric Code applies”
•
The approximate system boot time when the AC (or DC) power source is connected is
110 secs in Ubuntu Linux system. (The boot up time would depend on different NOS
system)
•
The approximate link time for the OOB Ethernet port when reconnected is 40 secs base
on Ubuntu Linux system (The link time would depend on different NOS system)
•
The design of the equipment is that the RTN terminal should be isolated from the chassis
or rack. (The DC input terminals is DC-I (Isolated DC return))
•
“WARNING: The intra -building port OOB (Ethernet) of the equipment or subassembly is
suitable for connection to intra-building or unexposed wiring or cabling only. The
intrabuilding port(s) of the equipment or subassembly MUST NOT be metallically
connected to interfaces that connect to the OSP or its wiring for more than 6 meters
(approximately 20 feet). These interfaces are designed for use as intra-building interfaces
only (Type 2, 4, or 4a ports as described in GR-1089) and require isolation from the
exposed OSP cabling. The addition of Primary Protectors is not sufficient protection in
order to connect these interfaces metallically to an OSP wiring system.”