UFESA AC6201, Инструкция по эксплуатации

Страница: 10 / 30

EPA OUTLET FILTER
The vacuum cleaners are equipped with an E11 outlet
filter EPA.
1
To replace the EPA filter lift the vacuum cleaner
handle and open the accessory compartment.
2
Grab the filter cover by the fastening, firmly pull
with the thumb and lift it upwards.
3
Remove the EPA filter case and replace it with
a new one. The EPA filter ensures an effective
operation of the vacuum cleaner for about 1 year.
4
Insert the cover so that the two protrusions in the
lower part of the cover are inserted in the openings of
the vacuum cleaner body, press the filter cover so that
the rear fastenings snap shot on the body.
● Close the accessory compartment and lift down the
handle.
INLET FILTER
1
Release the upper cover fastening (12) and open
the cover.
2
Remove the SAFBAG dust bag module (18) from
the vacuum cleaner chamber.
3
Slide the inlet filter casing with the installed inlet
filter from the tracks on the back side of the vacuum
cleaner chamber.
4
Remove the inlet filter (16) from the inlet filter casing.
5
Place the new filter in the inlet filter casing (17) with
the material side directed towards the inside of the casing.
6
Slide the inlet filter casing (17) together with the
filter in the tracks until stop to the previous position.
Always replace a damaged inlet filter
(16) with a brand new, original one.
7
Insert the SAFBAG dust bag module to the
vacuum cleaner chamber.
8
Close the cover by pressing it until you hear
a characteristic click – pay attention not to trap the
dust bag.
End of operation cleaning and
maintenance
1
Switch off the vacuum cleaner by pressing the “on/
off” button (7) .
2
Unplug the appliance.
3
Wind the cord by pressing the cord rewind button
(4)
. While doing this hold the cord to make sure it
D
E
F
is not tangled and the plug does not hit the vacuum
cleaner housing.
4
Disconnect the telescopic tube from the nozzle or
brush.
5
Disconnect the telescopic tube from the hose.
In order to remove the tube from the hose handle
press the “A” locking device and pull the tube in the
direction of the arrow.
6
Press the two side buttons on the end of the hose
and remove the hose end from the inlet opening of the
vacuum cleaner.
7
The vacuum cleaner may be stored vertically or
horizontally. In order to do so, insert the fastening hook
of the combination brush to the combination brush
fastener. The hose may be attached to the vacuum
cleaner, however you have to make sure that it is not
excessively bent during storing.
8
If necessary wipe the housing and the dust bag
container with a damp cloth (it may be soaked with
dishwashing liquid) and dry it or wipe until dry.
Do not use abrasive detergents or
solvents.
Examples of problems while operating
the vacuum cleaner
PROBLEM ACTION
A characteristic
“fluttering” of the
vacuum cleaner is
heard.
● Check the dust bag and the
accessories, remove the cause
of the clogging or replace the
dust bag with a new one.
● Clean the vacuum cleaner
chamber and the filter.
The dust bag is
damaged.
Remove the dust bag and the
filters.
The electrical
installation fuse
went out.
Check if other appliances
are not plugged to the same
electrical circuit as the
vacuum cleaner. If the fuse
goes out repeatedly, return the
vacuum cleaner to a service
point.
The vacuum
cleaner does
not operate;
the housing or the
cord is damaged.
Return the vacuum cleaner to
a service point.