UEi IRP-2, Быстрый старт

Страница: 5 / 8

5
Page 5
Lay the free end of paper over the printer head, past the serrated paper cutter onto the body
of the front of the printer’s case. Now close the paper cover and gently press down until it
locks into place. Start the paper feed sequence to confirm that the paper has been correctly
loaded. Tear off the excess paper by pulling it against the paper cutter.
WARNING. Never pull the paper through the printer always use “paper feed”.
Note: if the ‘paper out’ warning light is still flashing (see below) switch the printer off and then
on again.
STATUS INDICATOR ( RED LIGHT )
PAPER OUT
The IRP -2 will automatically detect when the paper has run out, the STATUS
INDICATOR will repeatedly flash.
LOW BATTERY
Low battery is indicated by the STATUS INDICATOR flashing three times.
Connect the AACA4 to the charging socket shown in Fig 2.
HEAD THERMAL LIMIT
In the event of extensive printing periods the temperature of the thermal head of the
IRP-2 may rise to an unusable level, if this occurs the STATUS INDICATOR will flash twice
and printing will be suspended until the temperature falls to an acceptable level.
DC 5V
Lay the free end of paper over the printer head, past the serrated paper cutter onto the
body of the front of the printer’s case. Now close the paper cover and gently press down
until it locks into place. Start the paper feed sequence to confirm that the paper has been
correctly loaded. Tear off the excess paper by pulling it against the paper cutter.
WARNING. Never pull the paper through the printer always use “paper feed”.
Note: if the ‘paper out’ warning light is still flashing (see below) switch the printer off and
then on again.
STATUS INDICATOR ( RED LIGHT )
PAPER OUT
The IRP-2 will automatically detect when the paper has run out, the STATUS INDICATOR
will repeatedly flash.
LOW BATTERY
Low battery is indicated by the STATUS INDICATOR flashing three times. Connect the USB
lead (WIR00067) and battery charger (PLU00066) to the charging socket shown in Fig 2.
HEAD THERMAL LIMIT
In the event of extensive printing periods the temperature of the thermal head of the IRP-2
may rise to an unusable level, if this occurs the STATUS INDICATOR will flash twice and
printing will be suspended until the temperature falls to an acceptable level.