FEATURES
• 600V AC/DC
• 200A AC
• 2000Ω Resistance
• Audible continuity
• Data hold
• Auto ranging
• Low battery indicator
• Auto power off
• Permanent test leads
• Storage for test leads
• Auto calibration
• Latches for battery compartment
GENERAL SPECIFICATIONS
• Operating Temperature:
32˚ to 104˚F (0˚ to 40˚C)
• Storage Temperature
14˚ to 122˚F (-10˚ to 50˚C)
• Operating Humidity:
<75%
• Operating Altitude:
6,562ft (2,000m)
• Pollution Degree:
2
• Display:
3 1/2” digits 2000 count
• Refresh Rate:
3/sec
• Over-range:
“OL” is displayed
• Dimensions:
8.66” X 2.72” X 1.56”
• Item Weight:
11.9 oz
• Calibration:
Recommended Annually
• CAT Rating:
CATIII 600V
• Certifications:
cETLus 3rd Edition,
CATIII 600V, CE Conformity,
IP41,
RoHS Compliant,
6’ Drop Protection, IEC 61010-1 3rd Edition
• Battery Type:
(AAA) X 2
• Accuracy:
± (% of r # of least significant digits)
IMPORTANT SAFETY WARNINGS
WARNING
Read entire Safety Notes section regarding potential hazard and proper
instructions before using this meter. In this manual the word “
WARNING
” is
used to indicate conditions or actions that may pose physical hazards to the
user. The word “
CAUTION
” is used to indicate conditions or actions that may
damage this instrument.
WARNING
To ensure safe operation and service of the tester, follow these instructions.
Failure to observe these warnings can result in severe injury or death.
WARNING
• Before each use, verify meter operation by measuring a known voltage
or current.
• Never use the meter on a circuit with voltages that exceed the category
based rating of this meter.
• Do not use this meter during electrical storms or in wet weather.
• Do not use the meter or test leads if they appear damaged.
• Always grip the leads behind the finger guards molded into the probe.
• Use caution when working with voltages above 60V DC or 25V AC RMS.
Such voltages pose shock hazards.
• To avoid false readings that can lead to electrical shock, replace batteries if
a low battery indicator appears.
• Unless measuring voltage or current, shut off and lockout power before
measuring resistance or capacitance.
• Always adhere to national and local safety codes. Use proper personal
protective equipment (PPE) to prevent shock and arc blast injury where
hazardous live conductors are exposed.
• Always turn off power to a circuit or assembly under test before cutting,
unsoldering or breaking the current path. Even small amounts or current
can be dangerous.
• Always disconnect the live test lead before disconnecting the common test
lead from the circuit.
• In the event of electrical shock, ALWAYS bring the victim to the emergency
room for evaluation, regardless of victim’s apparent recovery. Electrical
shock can cause unstable heart rhythms that may need medical attention.
• If any of the following occur during testing, turn off the power source to
the circuit being tested: arching, flame, smoke, extreme heat, smell of
burning materials or discoloration/melting of components.
WARNING
Higher voltages and currents require greater awareness of physical safety
hazards. Set meter to desired function prior to applying test leads to a live
circuit. If an erroneous reading is observed, disconnect test leads immediately,
recheck all settings and connections before testing again.
WARNING
This meter is designed for trade professionals who are familiar with the
hazards of their trade. Observe all recommended safety procedures that
include proper lock-out utilization and use of personal protective equipment
that includes safety glasses, gloves and flame resistant clothing.
