WARRANTY
The C161 combustion analyzer is warranted for one year including sensors. If within the warranty period
your instrument should become inoperative from such defects, the unit will be repaired or replaced at
UEi’s option. This warranty covers normal use and does not cover damage which occurs in shipment or
failure which results from alteration, tampering, accident, misuse, abuse, neglect or improper mainte-
nance (calibration). Batteries and consequential damage resulting from failed batteries are not covered
by warranty. Any implied warranties, including but not limited to implied warranties of merchantability
and fitness for a particular purpose, are limited to the express warranty. UEi shall not be liable for loss
of use of the instrument or other incidental or consequential damages, expenses, or economic loss, or
for any claim or claims for such damage, expenses or economic loss. A purchase receipt or other proof
of original purchase date will be required before warranty repairs will be rendered. Instruments out of
warranty will be repaired (when repairable) for a service charge. Warranty only covers hardware and
does not extend to software applications. Contact UEi for specific warranty and service information.
UEi Test Instruments • 1-800-547-5740 • [email protected]
This warranty gives you specific legal rights. You may also have other rights which vary from state to state.
Download the full
Owners Manual at
UEiTEST.COM or
SCAN THIS CODE
POST TESTING
BATTERIES
The analyzer is fitted with 3
(AA) size rechargeable batter-
ies. Observe correct polarity
when replacing.
Always check operation
immediately after battery
replacement.
Do not leave batteries in unit for
extended periods of non-use.
WARNING
Do not recharge with Alka-
line batteries fitted. Alkaline
batteries are not rechargeable.
Attempting to recharge alkaline
batteries may result in product
damage and create a fire risk.
Time and Date will need to be
reset after changing batteries.
Always dispose batteries using
approved disposal methods that
protect the environment.
Remove the probe from the flue
and allow analyzer to purge with
fresh air until readings return to
zero. O2 to 20.9%, CO to Zero
CAUTION:
probe tip will be HOT.
POWERING OFF
When you power off the C161, there is a 10 second purge.
CAUTION
Make sure you do not exceed the analyzer’s operating specifications.
• Do not exceed the flue probes maximum temperature (1112˚F)
• Do not exceed the analyzer’s internal temperature range 112°F (50°C)
• Do not put the analyzer on a hot surface
• Do not exceed the water trap’s level
• Do not let the particle filter become dirty and blocked
