english
D
EN-46
EN-47
english
D
Technical information
Technical information
1. Failure and error messages
Failure
encountered
Possible cause
Corrective action
Display Err
- 300
Excessive cuff pressure. Cuff inflated
to maximum due to movement of
the arm or body.
The hose may be kinked or the air
connector blocked.
- Repeat measurement
- Do not move arm
- Do not talk
- Check that hose with air
connector is clear (unobstructed)
Display Err - 1
Measurement error. Measurement
could not be carried out due to
movement of the arm or body.
- Repeat measurement
- Do not move arm
- Do not talk
Display Err - 2
Inflation error, pressure built up too
quickly or too slowly.
Check seating of air connector,
repeat measurement.
Fault was recognised.
- Repeat measurement
- Do not move arm
- Do not talk
Irregular heartbeat, disruptive
movements, shaking, wobbling
(objects), breathing in deeply, etc.
Repeat measurement after 3-5
minutes rest. Possible factors
(depending on the severity of
the arrhythmia) affecting the
measurement results must be
discussed with your doctor.
Unusual
measured
values
Movement or talking during
measurement, resting time not
observed, feet possibly crossed,
smoking or coffee cunsumption.
Check conditions and repeat
measurement. Observe
instructions for use P. EN-36.
Failure
encountered
Possible cause
Corrective action
Display 0
0
Start/Stop button accidentally
pressed while battery was
being changed.
Switch unit off and then on again
with Start/Stop button.
Measurement was
interrupted and
cuff first deflated
and then inflated
Strong pulse restlessness or
movement detected, unit
rejects measurement
If necessary, interrupt
measurement, measure again after
a break of 5 minutes.
Movement during
measurement
If necessary, interrupt
measurement, measure again after
a break of 5 minutes.
No display after
unit is switched on
Batteries inserted incorrectly?
Check position of batteries.
Batteries flat?
Change batteries.
Battery compartment dirty?
Clean battery compartment.
Dashes in display
after Memory
button is pressed
No measured values stored.
No display when no measured
values are stored.
Batteries flat?
Change batteries.
Measurement
interrupted
Batteries flat?
Change batteries.
Measured values
extremely high
or low
Was the correct measurement
position maintained?
Repeat measurement, ensuring
correct body posture. Do not move
your arm and do not speak.
Was the necessary
rest observed prior to
measurement?
Repeat measurement after a break
of approx. 3-5 mins.
- Do not move arm
- Do not talk
Содержание Visomat Comfort 20
Страница 58: ...italiano IT 110 IT 111 italiano ...