5
6
FLIGHT PREPARATION
UA15 Controller
Your U846 quadcopter includes either a UA15 or UA14 controller.
The UA15 Controller uses 2 AAA batteries (not included).
Install 2 AAA Batteries in the UA15 Controller.
To assemble the Controller, install 2 1.5V AAA batteries (not included)
in the controller/ transmitter. Press the tab on the battery cover to
open and then close the cover over the battery compartment.
UA14 Controller
The UA14 Controller uses a Li-Po battery (included).
Install the Li-Po Battery in the UA14 Controller
To assemble the Controller, install the included Li-Po battery the
controller/ transmitter. Slide the battery cover down to open.
Attach the power connector on the battery to the matching
connector in the controller. Slide the battery cover back to close.
• This product is equipped with a Li-Po battery. Please take note of
appropriate safety precautions when not in use.
• Do not expose the charged battery to high temperatures, such as
flames or near electronic devices. This may cause damage or explosion.
• Make sure all batteries are connected in the proper orientation to avoid
damage or explosion.
• Do not use the battery to impact any hard surfaces. Avoid contact with
metal.
• If the battery becomes damaged, bulges, or appears to change shape,
please stop using the battery and discard it.
• When charging the battery, to avoid accident, put the power supply
on the ground. Avoid setting the charger on cloth or other flammable
materials because the charger will get hot.
• Do not immerse the battery in water. The battery should be kept in a
dry place.
• Do not break the battery or attempt to open the battery.
• Do not leave the battery charging without supervision.
2. Warnings
“AAA” batteries
Battery Cover
CHARGING LI-PO BATTERY
Connect the Li-Po battery in the quadcopter to USB before plugging
the USB to power or your computer. One end of the USB charger
goes into any free port on your computer or USB power bank. The
other end plugs into the charging connector on your copter. The
battery in the copter is not removable. While charging, the light will
be off. When charging is complete, the light will be on. The recharge
time should be around 40 minutes.
1. Charge the Battery
