7
Pre-Flight Operation:
1. Turn on the transmitter switch and the LED indicator begins to flash rapidly. Push the
Left Stick all the way down to the lowest position and then release. The Left Stick will
back to the middle position automatically. The LED indicator starts flash slowly, which
indicates the transmitter enters frequency pairing.
2. Install the battery to the mounted box and power on the drone.
3. Put the drone on the flat surface, the drone body lights turn from flashing to solid bright,
which indicates successful frequency pairing.
Important Notice: Please make sure the gyro of the receiving board is placed on the
horizontal position after powering on the drone, so that the drone can
work well.
4. Do not move the Left Stick before successful calibration. Move the Right Stick to the
right rear direction and then release. The drone body light change from flashing to solid
bright, which indicates successful calibration.
Picture 4
Altitude Hold Mode
Altitude hold mode indicates that the drone maintains a
consistent altitude while allowing roll, pitch, and yaw to be
controlled normally. It makes it easier to control the drone for
beginner and more stable for aerial photography.
Push the Left Stick up (down) to fly the drone up (down) at
certian altitude and then release the stick and the stick will back
to the center position as the right picture shown. And the drone
will keep flying at ceitain altitude. Repeat the below steps if you
want to change the drone altitude.
Off / Landing / Emergency
Landing Button
Picture 5
Two Take Off Modes
Three Landing Modes
1. Take off: Push the Left Stick and Right Stick as Picture 4 shown to start the motor and
then release. Then push up the Left Stick to fly up the drone to certain altitude and
then release the stick.
2. One button take off: Press the Take Off / Landing / Emergency Landing button, the
drone will fly up automatically and keep flying at an altitudel of 1.2 meters.
1. Landing: Push the Left Stick all the way down to the lowest position and hold it till the
motors stop and the drone lands on the ground.
2. One Button Landing: Press the Take Off / Landing / Emergency Landing button once
shortly, and the drone will fly down slowly till land on the ground automatically.
3. Emergency Landing: When the drone in emergency situation and going to hit the
walking people or obstacle etc., press the Take Off / Landing / Emergency Landing
button immediately and hold it for about 1s. The motor will stop immediately and the
drone will land on the ground automatically.
Altitude Hold Certer
