5
6
Calibration Instruction
Please follow below steps to calibrate the drone if the drone becomes imbalance after
crashing during the flight, and can not be adjusted by trimmer button and cause difficult
operation.
1. Power off the drone, then turn off the transmitter switch.
2. Turn on the transmitter switch, push the Left Stick all the way down to the lowest
position (Picture 1) and then release. The Left Stick will back to the middle position
automatically (Picture 2). The transmitter enters frequency pairing mode.
3. Power on the drone and put it on a flat surface in a
horizontal position. The LED lights change from flash
to solid bright, which indicates successful frequency
pairing.
4. Do not move the Left Stick before successful calibration.
Push the Right Stick as shown in Picture 3 and then
release. The drone body light flashes, which indicates
that the drone is calibrating. When the drone body
lights remain solid, which indicates successful calibration.
Notice: Fail to calibrate may cause loss of drone function.
Picture 1
Picture 3
Picture 2
Pre-Flight Instruction:
1. The green LED lights are front and the orange LED lights are rear.
2. Power on the drone and check the direction of the rotating propellers. The left front
and right rear A propellers rotating clockwise while the right front and left rear B
propellers rotating counterclockwise.
3. Adjust relative transmitter Trimmer button to adjust the rudder if the drone tilts to one
side when flying.
B Propeller
Counterclockwise
A Propeller
Clockwise
B Propeller
Counterclockwise
A Propeller
Clockwise
Front
Left
Right
Rear
2. The red USB indicator light keeps bright when charging.
3. The charging time is about 70 minutes. The light turns to green when fully charged.
4. Li-Po battery is included in spare parts and please pay attention on the safe notice.
* Do not put the battery on high temperature place, such as fire or heating device to
avoid damage or explode.
* Do not use the battery to crash or hit hard surface.
* Do not put the battery in water and keep it in dry place.
* Do not open the battery.
* Do not leave the battery without supervision when charging.
* Make sure that there is no short circuit of the power wire.
* Please use the recommended charger only.
* Check the charger’s wire, plug, surface regularly. Do not use broken charger.
1. Connect the drone battery with USB plug first and then choose one of the method as
below picture to connect with USB plug. (prior to choose 2A, 5V charger)
Transmitter Installation:
Charging Instruction
Battery installation: open the battery cover on the back side of the transmitter and put 4
alkaline batteries (not included) into the box in accordance with
electrode instructions.
Battery Cover
4X1.5V
Alkaline Batteries
1. Make sure the electrodes are correct.
2. Do not mixed use new and old batteries.
3. Do not mixed use different kinds of batteries.
4. Do not charge the non rechargeable battery.
Notice:
Li-Po Battery Disposal & Recycling
Wasted Lithium-Polymer batteries must not be placed with household trash.
Please contact local environmental or waste agency or the supplier
of your model or your nearest LiPo battery recycling center.
Drone Battery
Drive the screw according to the
arrow direction to loosen the
screw to open the battery cover.
Tighten the screw by driving it in
opposite direction.
