2.1.7 Select Battery Charge State
Press UP/DOWN key to select battery charge status: Before Charge or After Charge, then press OK key to
confirm. This way can
ensure
a more accurate test result.
NOTE:
In Vehicle, select Before Charge for Cold Vehicle and After Charge for Hot Vehicle.
2.1.8 Select Battery Type
Press UP/DOWN key to select battery type, i.e. Regular Flooded, AGM Flat Plate, AGM Spiral, and Gel battery.
Press UP/DOWN key to select battery type and press OK key to confirm. When it's on IN-VEHICLE test, battery
installation way shall also be selected, e.g. TOP, SIDE or REMOTE (This selection is no need for
OUT-OF-VEHICLE), then press OK key to confirm. REMOTE is adopted for some in vehicle battery which is too
tightly installed to use the test clamps to connect the battery poles.
NOTE:
For REMOTE test, there will be a little tolerance. For any doubt, take off the battery and select
"OUT-OF-VEHICLE" to re-test.
2.1.9 Battery System Standard and Rating
Use UP/DOWN key to select according to the actual system standard and rating marked on the battery. See in
the below picture, the arrow indicated location.
.
STLECT CHARGE
BEFORE CHARGING
SELECT CHARCE
AFTER CHARGING
CCA
Cold Cranking Amps, specified by SAE&BCI, most frequently used value for
starting battery at 0°F (-18°C)
BCI
Battery Council International standard
CA
Cranking Amps standard, effective starting current value at 0°C
MCA
Marine Cranking Amps standard, effective starting current value at 0°CJapan Industrial
Standard, displayed on the battery as combination of the numbers and letters, e.g. 55D23,
80D26.
DIN
German Auto Industry Committee Standard
IEC
Internal Electro technical Commission Standard
EN
European Automobile Industry Association Standard
SAE
Society of Automotive Engineers Standard
GB
China National Standard
CELECT INPUT
CCA
SET PATING
500A CCA
TESTING
***
Input correct test standard and rating, press OK key, tester starts to test, and dynamic interface
"TESTING" prompted. See above.
5