UCL SWIFT KR12A, Руководство пользователя

Страница: 99 / 103

97
You cannot change arc amount and time in SM, NZ, MM or Auto
mode. A proper arc discharge amount can be maintained in these
modes by performing [Arc Calibration]. The Arc amount and time will
set automatically to prevent from being changed in other mode.
o
How to set pause.
Refer to [Option Menu].
o
Difference between estimated splice loss and measured splice loss.
The estimated splice loss is just a result from computation so it has
to be used for reference only.
9.3 Sleeve heater
o
The sleeve heater does not give sufficient shrinkage.
Increase the duration of heating time. Refer to [Heat Menu] for more
information.
o
The sleeve heater is overheated.
Stop the operation of the heater by pressing . Turn off the
power and contact UCLSWIFT Co., Ltd.
When the sleeve is not separated from the heating plate, use a
cotton swab or a similar object to this to push or remove the sleeve.
o
How to initialize the heating condition in the heat mode?
Refer to [Heat Menu] for more information.
o
How to cancel the heating process?
You cannot cancel the heating process by pressing
.
Press
one more time to cancel it.