UCL SWIFT KR12A, Руководство пользователя

Страница: 63 / 103

61
Proof test
If [Proof Test] is set to “ON”, a test is
carried out during the opening the
windshield after splicing or pressing
RESET.
Non
Editable
Editable
Cleaning Power
A short period of arc discharge is
performed to remove the fine dust on the
fiber surface as setting the distance
between the cross sections of the fibers.
Cleaning Time The duration of arc discharge is set.
Gap
It sets the distance between the left fiber
and right fiber.
Gap set Pos.
It sets the position of the fibers to the
center of arc discharge.
Prefuse Power
It is set by the prefuse power from the
beginning of arc to the moment before the
fibers start moving forward. At this
moment, if the initial value is too low, the
axis’ offset can occur due to bad cross
section angle of the fiber.
On the other hand, if the initial value is too
high, the fiber can be burned out or
shaped round, resulting in aggravating the
splice loss.
Prefuse Time
It is set by the prefuse time beginning of
arc to the moment before the fibers start
moving forward.
The meaning of [long Prefuse time]
indicates greater [Prefuse power].
Overlap
It sets the duplication amount of the fiber
from the forward amount.
If [prefuse power] is weak or [prefuse
time] is not long enough, the [overlap]
needs to be smaller. On the other hand, it
should be set to bigger if the arc is strong
or the time is longer.