SARA-R5 series - System integration manual
UBX-19041356 - R04
Approvals
Page 105 of 118
C1-Public
4.2.2
Declaration of Conformity
This device complies with Part 15 of FCC rules. Operation is subject to the following two conditions:
•
this device may not cause harmful interference
•
this device must accept any interference received, including interference that may cause
undesired operation
⚠
Radiofrequency radiation exposure information: this equipment complies with the radiation
exposure limits prescribed for an uncontrolled environment for fixed and mobile use conditions.
This equipment should be installed and operated with a minimum distance of 20 cm between the
radiator and the body of the user or nearby persons. This transmitter must not be co-located or
operating in conjunction with any other antenna or transmitter except as authorized in the
certification of the product.
⚠
The gain of the system antenna(s) used for the SARA-R5 series modules (i.e. the combined
transmission line, connector, cable losses and radiating element gain) must not exceed the value
specified in the FCC Grant for mobile and fixed or mobile operating configurations:
o
7.8 dBi in 700 MHz, i.e. LTE FDD-12 band
o
9.2 dBi in 750 MHz, i.e. LTE FDD-13 band
o
9.4 dBi in 850 MHz, i.e. LTE FDD-5 band
o
7.4 dBi in 850 MHz, i.e. LTE FDD-26 band
o
6.8 dBi in 1700 MHz, i.e. LTE FDD-4 band
o
10.3 dBi in 1900 MHz, i.e. LTE FDD-2 band
o
10.4 dBi in 1900 MHz, i.e. LTE FDD-25 band
4.2.3
Modifications
The FCC requires the user to be notified that any changes or modifications made to this device that
are not expressly approved by u-blox could void the user's authority to operate the equipment.
⚠
Manufacturers of mobile or fixed devices incorporating SARA-R5 series modules are authorized to
use the FCC Grants of the SARA-R5 series modules for their own final host products according to
the conditions referenced in the certificates.
⚠
Manufacturers of mobile or fixed devices incorporating SARA-R5 series modules are authorized to
use the FCC Grants of the SARA-R5 series modules for their own final host products if, as per FCC
KDB 996369, the antenna trace design implemented on the host PCB is electrically equivalent to
the antenna trace design implemented on the u-blox host PCB used for regulatory type approvals
of the SARA-R5 series modules, described in details in section
⚠
In case of antenna trace design change, an FCC Class II Permissive Change application is required
to be filed by the grantee, or the host manufacturer can take responsibility through the change in
FCC ID (new application) procedure followed by an FCC Class II Permissive Change application.
⚠
If the FCC Grants of the SARA-R5 series modules can be used for the final host product, as the
conditions above are met, the FCC Label of the module shall be visible from the outside, or the host
device shall bear a second label stating:
"Contains FCC ID: XPYUBX19KM01"
⚠
IMPORTANT: Manufacturers of portable applications incorporating the SARA-R5 series modules
are required to have their final product certified and apply for their own FCC Grant related to the
specific portable device. This is mandatory to meet the SAR requirements for portable devices.
Changes or modifications not expressly approved by the party responsible for compliance could
void the user's authority to operate the equipment.
