Ubitekk CC1, Руководство пользователя

Страница: 20 / 31

17
Select “File -> Load Flash Image…” from the menu, as shown in Figure 15. Once the proper file
is selected, the uploading of the firmware should begin immediately.
Figure 15. Creating a programming file for the RCM3400.
On some systems, the port location of the Rabbit Programming Cable may not be recognized
automatically. If this happens, you will get an error that says “Could not open serial port.” If this
occurs, you will need to select the “Setup -> Communications…” item in the DC RFU program
menu. This will open up a communications screen where you can select the proper COM port
that identifies your Rabbit Programming Cable. An example of this screen (with the proper COM
port settings) is shown in Figure 16:
Figure 16. Communication settings for the Rabbit Programming Cable.