3
Chapter 2: Installation
airFiber X User Guide
Ubiquiti Networks, Inc.
Chapter 2: Installation
Installation Requirements
The airFiber radio operates only with the antennas listed
below:
airFiber Radio
airFiber X Antenna
Rock Conversion Kit
AF-2X
AF-2G24-S45
n/a
AF-3X
AF-3G26-S45
n/a
AF-4X
AF-5G30-S45
AF-5G34-S45
RD-5G30 + AF-5G-OMT-S45
RD-5G34 + AF-5G-OMT-S45
AF-5X
AF-5G23-S45
AF-5G30-S45
AF-5G34-S45
RD-5G30 + AF-5G-OMT-S45
RD-5G34 + AF-5G-OMT-S45
See the antenna’s Quick Start Guide for antenna
installation instructions.
Other Requirements
•
Clear line of sight between airFiber X radios
•
Clear view of the sky for proper GPS operation
•
Vertical mounting orientation
•
Mounting point:
•
At least 1 m below the highest point on the structure
•
For tower installations, at least 3 m below the top of
the tower
•
Ground wires – min. 10 AWG (5 mm
2
) and max. length:
1 m. As a safety precaution, ground the airFiber X radio
to grounded masts, poles, towers, or grounding bars.
WARNING:
Failure to properly ground your
airFiber X radio will void your warranty.
•
(Recommended) 2 Outdoor Gigabit PoE surge protectors
Note:
For guidelines about grounding and
lightning protection, follow your local electrical
regulatory codes.
•
Outdoor, shielded Category 6 (or above) cabling and
shielded RJ-45 connectors are required for all wired
Ethernet connections.
Installation Overview
We recommend to configure your paired airFiber X radios
before site installation. The overview below summarizes
the installation procedure, and the subsequent sections
provide detailed installation information:
•
Connect the airFiber PoE Adapter
to the
DATA port, and
connect your computer and the MGMT port.
•
Configure the airFiber X radio.
•
Install a ground wire and mount the airFiber X radio on
an airFiber X antenna.
•
At the installation site, install the airFiber X antenna with
the mounted airFiber X radio (see the antenna’s Quick
Start Guide for installation instructions).
•
Secure the ground wire and mount the GPS antenna.
•
Establish and optimize the RF link.
Connecting Power over Ethernet
1. Lift the release latch on the bottom of the airFiber X
radio and slide the
Port Cover off.
2. Connect an Ethernet cable to the DATA port.
3. Connect the Ethernet cable from the DATA
port to the
Ethernet port labeled POE
on the
airFiber PoE Adapter.
WARNING:
Use only the included airFiber PoE
adapter, Model GP-H240-100G-4. Failure to do
so can damage the unit and void the product
warranty.
All manuals and user guides at all-guides.com
