LEDs
Signal LEDs
Signal 4
LED will light blue when on.
Signal 3
LED will light green when on.
Signal 2
LED will light yellow when on.
Signal 1
LED will light red when on.
Bootup to airOS
When powering on, the Power, GPS, LINK,
and Signal 1-4 LEDs light on. Once the CPU code takes over, the
GPS, LINK, and Signal 1-3 LEDs turn off. Signal 4 LED remains on
to indicate the boot sequence is underway.
Initializing airFiber Software
When the airFiber application
begins to boot under airOS, the Signal 4 LED goes from solidly
on to a 2.5 Hz flash. This continues until the AF-5XHD is fully
booted.
Signal Level
Once fully booted, the Signal 1-4 LEDs act as a
bar graph showing how close the AF-5XHD is to ideal aiming.
This is auto-scaled based on the link range, the antenna gains,
and the configured TX power of the remote AF-5XHD. Each
Signal LED has three possible states: On, Flashing, and Off. All
Signal LEDs would be solidly on in an ideal link. If the link has a
1 dB loss, the Signal 4 LED will flash; a 2 dB loss and the Signal
4 LED will turn off. The full bar graph LED states are shown
below.
dB
loss
0
-1
-2
-3
-4
-5
-6
-7
-8
-9 -10 -11 -12 -13
1
F
0
0
0
0
0
0
0
0
0
0
0
0
1
1
1
F
0
0
0
0
0
0
0
0
0
0
1
1
1
1
1
F
F
0
0
0
0
0
0
0
1
1
1
1
1
1
1
1
1
1
F
F
F
0
0 = Off, 1 = On, F = Flashing
